Cisco Catalyst 3120 Command Reference Guide

2-84
Cisco Catalyst Blade Switch 3120 for HP Command Reference
OL-12248-01
Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands
diagnostic monitor
Defaults Monitoring is disabled, and a failure threshold value is not set.
Command Modes Global configuration
Command History
Usage Guidelines Follow these guidelines when configuring health-monitoring diagnostic testing:
• name—Enter the show diagnostic content privileged EXEC command to display the test names in
the test ID list.
• test-id—Enter the show diagnostic content command to display the test numbers in the test ID list.
• test-id-range—Enter the show diagnostic content command to display the test numbers in the test
ID list. Enter the range as integers separated by a comma and a hyphen (for example, 1,3-6 specifies
test IDs 1, 3, 4, 5, and 6).
• hh—Enter the hours from 0 to 24.
• mm—Enter the minutes from 0 to 60.
• ss—Enter the seconds from 0 to 60.
• milliseconds—Enter the test time in milliseconds from 0 to 999.
• day—Enter the number of days between test from 0 to 20.
• Enter the diagnostic monitor test 1 command to enable diagnostic monitoring.
You must configure the failure threshold and the interval between tests before enabling diagnostic
monitoring.
When entering the diagnostic monitor switch number test {name | test-id | test-id-range | all}
command, you must isolate network traffic by disabling all connected ports, and do not send test packets
during the test.
Examples This example shows how to configure a health-monitoring test:
Switch(config)# diagnostic monitor threshold switch 2 test 1 failure count 20
Switch(config)# diagnostic monitor interval switch 2 test 1 12:30:00 750 5
Related Commands
Release Modification
12.2(40)EX This command was introduced.
Command Description
show diagnostic Displays online diagnostic test results.

Cisco Catalyst 3120 Specifications

General

Brand	Cisco
Model	Catalyst 3120
Category	Switch
Language	English