Cisco Catalyst 3120

2-133
Cisco Catalyst Blade Switch 3120 for HP Command Reference
OL-12248-01
Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands
hw-module
This example shows how to enable OBFL on a standalone switch and to specify that only severity 1
hardware-related messages are stored in the flash memory of the switch:
Switch(config)# hw-module module 1 logging onboard message level 1
You can verify your settings by entering the show logging onboard privileged EXEC command.
Related Commands Command Description
clear logging Removes the OBFL data in the flash memory.
show logging onboard Displays OBFL information.