Cisco Catalyst 3120

2-379
Cisco Catalyst Blade Switch 3120 for HP Command Reference
OL-12248-01
Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands
setup
interface GigabitEthernet6/0/2
no ip address
!
end
Use this configuration? [yes/no]: yes
!
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
Enter your selection [2]:
Related Commands Command Description
show running-config Displays the operating configuration. For syntax information, use
this link to the Cisco IOS Release 12.2 Command Reference listing
page:
http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/prod_co
mmand_reference_list.html
Select the Cisco IOS Commands Master List, Release 12.2 to
navigate to the command.
show version Displays version information for the hardware and firmware.