Cisco Catalyst 3120 Command Reference Guide

B-37
Cisco Catalyst Blade Switch 3120 for HP Command Reference
OL-12248-01
Appendix B Cisco Catalyst Blade Switch 3120 for HP Debug Commands
debug platform ip igmp snooping
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug platform ip igmp snooping command is the same as the no debug platform ip igmp
snooping command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands
rpc [cfg | l3mm | misc
| vlan]
Display IGMP snooping remote procedure call (RPC) event debug messages.
The keywords have these meanings:
• cfg—(Optional) Display IGMP snooping RPC debug messages.
• l3mm—(Optional) IGMP snooping Layer 3 multicast router group RPC
debug messages.
• misc—(Optional) IGMP snooping miscellaneous RPC debug messages.
• vlan—(Optional) IGMP snooping VLAN assert RPC debug messages.
warn Display IGMP snooping warning messages.
Release Modification
12.2(40)EX This command was introduced.
Command Description
debug ip igmp
snooping
Displays information about platform-independent IGMP snooping activity.
show debugging Displays information about the types of debugging that are enabled.

Cisco Catalyst 3120 Specifications

General

Brand	Cisco
Model	Catalyst 3120
Category	Switch
Language	English