Cisco Catalyst 3120 Command Reference Guide

B-76
Cisco Catalyst Blade Switch 3120 for HP Command Reference
OL-12248-01
Appendix B Cisco Catalyst Blade Switch 3120 for HP Debug Commands
debug spanning-tree mstp
Usage Guidelines The undebug spanning-tree mstp command is the same as the no debug spanning-tree mstp
command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands Command Description
show debugging Displays information about the types of debugging that are enabled.
show spanning-tree Displays spanning-tree state information.

Cisco Catalyst 3120 Specifications

General

Brand	Cisco
Model	Catalyst 3120
Category	Switch
Language	English