Cisco Catalyst 3650

CHAPTER 4
Configuring IGMP Proxy
•
Finding Feature Information, page 89
•
Prerequisites for IGMP Proxy, page 89
•
Information about IGMP Proxy, page 90
•
How to Configure IGMP Proxy, page 92
•
Configuration Examples for IGMP Proxy, page 96
•
Where to Go Next for IGMP Proxy, page 97
•
Additional References, page 98
•
Feature History and Information for IGMP Proxy, page 99
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest feature
information and caveats, see the release notes for your platform and software release.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not
required.
Prerequisites for IGMP Proxy
•
All devices on the IGMP UDL have the same subnet address. If all devices on the UDL cannot have the
same subnet address, the upstream device must be configured with secondary addresses to match all of
the subnets to which the downstream devices are attached.
•
IP multicast is enabled and the PIM interfaces are configured.
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
OL-29890-01 89