Cisco Catalyst 3650

!
ip pim ssm default
Related Topics
SSM Components Overview, on page 233
Configuring Source Specific Multicast, on page 237
Where to Go Next for SSM
You can configure the following:
•
IGMP
•
Wireless Multicast
•
PIM
•
IP Multicast Routing
•
Service Discovery Gateway
You can also review the following IP Multicast Optimization processes for your configuration:
•
Optimizing PIM Sparse Mode in a Large IP Multicast Deployment
•
Multicast Subsecond Convergence
•
IP Multicast Load Splitting across Equal-Cost Paths
•
SSM Channel Based Filtering for Multicast
•
PIM Dense Mode State Refresh
•
IGMP State Limit
Additional References
Related Documents
Document TitleRelated Topic
IP Multicast Routing Command Reference (Catalyst
3650 Switches)
For complete syntax and usage information for the
commands used in this chapter.
•
IP Multicast: PIM Configuration Guide, Cisco
IOS XE Release 3SE (Catalyst 3650 Switches)
•
IP Multicast: IGMP Configuration Guide, Cisco
IOS XE Release 3SE (Catalyst 3650 Switches)
•
IP Multicast: Multicast Optimization
Configuration Guide, Cisco IOS XE Release
3SE (Catalyst 3650 Switches)
Platform-independent configuration information
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
OL-29890-01 247
Configuring SSM
Where to Go Next for SSM