Cisco Catalyst 3650

Where to Go Next for PIM
You can configure the following:
•
IGMP
•
Wireless Multicast
•
SSM
•
IP Multicast Routing
•
Service Discovery Gateway
You can also review the following IP Multicast Optimization processes for your configuration:
•
Optimizing PIM Sparse Mode in a Large IP Multicast Deployment
•
Multicast Subsecond Convergence
•
IP Multicast Load Splitting across Equal-Cost Paths
•
SSM Channel Based Filtering for Multicast
•
PIM Dense Mode State Refresh
•
IGMP State Limit
Additional References
Related Documents
Document TitleRelated Topic
•
Protocol Independent Multicast (PIM):
Motivation and Architecture
•
Protocol Independent Multicast (PIM), Dense
Mode Protocol Specification
•
Protocol Independent Multicast (PIM), Sparse
Mode Protocol Specification
•
draft-ietf-idmr-igmp-v2-06.txt, Internet Group
Management Protocol, Version 2
•
draft-ietf-pim-v2-dm-03.txt, PIM Version 2
Dense Mode
PIM is defined in RFC 4601 and in these Internet
Engineering Task Force (IETF) Internet drafts.
IP Multicast Routing Command Reference (Catalyst
3650 Switches)
For complete syntax and usage information for the
commands used in this chapter.
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
160 OL-29890-01
Configuring PIM
Where to Go Next for PIM