Cisco Catalyst 3650 User Manual

PurposeCommand or Action
Returns to privileged EXEC mode.end
Example:
Device(config)# end
Step 7
Verifies your entries.show running-config
Step 8
Example:
Device# show running-config
Displays active RPs that are cached with associated multicast routing entries.show ip pim rp mapping
Step 9
Example:
Device# show ip pim rp mapping
Displays the information cached in the routing table.show ip pim rp
Step 10
Example:
Device# show ip pim rp
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Step 11
Example:
Device# copy running-config
startup-config
Related Topics
Auto-RP, on page 117
Example: Configuring Auto-RP, on page 157
Adding Auto-RP to an Existing Sparse-Mode Cloud (CLI)
This section contains suggestions for the initial deployment of Auto-RP into an existing sparse-mode cloud
to minimize disruption of the existing multicast infrastructure.
This procedure is optional.
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
OL-29890-01 131
Configuring PIM
Configuring a Rendezvous Point

Cisco Catalyst 3650 Specifications

General

Switching Capacity	160 Gbps
Uplink Interfaces	4 x 1G SFP or 2 x 10G SFP+
Device Type	Switch
Form Factor	Rack-mountable
Layer	Layer 3
DRAM	4 GB
Flash Memory	4 GB
Operating System	Cisco IOS XE
Model	Catalyst 3650
Ports	24 or 48 10/100/1000 Ethernet ports
Stacking	Yes
Power over Ethernet (PoE)	Yes
Power Supply Options	350W AC
VLANs	4094