Cisco Catalyst 3650 User Manual

•
PIM
•
SSM
•
IP Multicast Routing
You can also review the following IP Multicast Optimization processes for your configuration:
•
Optimizing PIM Sparse Mode in a Large IP Multicast Deployment
•
Multicast Subsecond Convergence
•
IP Multicast Load Splitting across Equal-Cost Paths
•
SSM Channel Based Filtering for Multicast
•
PIM Dense Mode State Refresh
•
IGMP State Limit
Additional References
Related Documents
Document TitleRelated Topic
IP Addressing: DNS Configuration Guide, Cisco IOS
XE Release 3SE
Configuring DNS
'Information About DNS' section in IP Addressing:
DNS Configuration Guide, Cisco IOS XE Release
3SE
DNS conceptual information
IP Addressing: DNS Configuration Guide, Cisco IOS
XE Release 3SE
Platform-independent configuration information
Error Message Decoder
LinkDescription
https://www.cisco.com/cgi-bin/Support/Errordecoder/
index.cgi
To help you research and resolve system error
messages in this release, use the Error Message
Decoder tool.
Standards and RFCs
TitleStandard/RFC
DNS-Based Service Discovery
RFC 6763
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
290 OL-29890-01
Configuring the Service Discovery Gateway
Additional References

Cisco Catalyst 3650 Specifications

General

Switching Capacity	160 Gbps
Uplink Interfaces	4 x 1G SFP or 2 x 10G SFP+
Device Type	Switch
Form Factor	Rack-mountable
Layer	Layer 3
DRAM	4 GB
Flash Memory	4 GB
Operating System	Cisco IOS XE
Model	Catalyst 3650
Ports	24 or 48 10/100/1000 Ethernet ports
Stacking	Yes
Power over Ethernet (PoE)	Yes
Power Supply Options	350W AC
VLANs	4094