Cisco Catalyst 3650

Enabling Multicast DNS Gateway (GUI)
SUMMARY STEPS
1.
Choose Configuration > Controller > mDNS > Global.
2.
Select the mDNS gateway check box.
3.
From the Learn Service drop-down list, choose from the following options:
• Enable— Allows the device to learn all the announced services. It is used to learn services by
enabling all announcement/queries by using Service Policy IN of type GUI-permit-all and in Service
Policy OUT of type GUI-deny-all.
• Disable— Denies all the traffics IN and OUT. It is used to deny services by disabling all
announcement/queries by using Service Policy IN of type GUI-deny-all and in Service Policy OUT
of type GUI-deny-all.
• Custom— You can set your own IN and OUT policy. It allows you to define a custom service list.
4.
Click Apply.
5.
Click Save Configuration.
DETAILED STEPS
Step 1
Choose Configuration > Controller > mDNS > Global.
The Global Service Rules page is displayed.
Step 2
Select the mDNS gateway check box.
Step 3
From the Learn Service drop-down list, choose from the following options:
• Enable— Allows the device to learn all the announced services. It is used to learn services by enabling all
announcement/queries by using Service Policy IN of type GUI-permit-all and in Service Policy OUT of type
GUI-deny-all.
• Disable— Denies all the traffics IN and OUT. It is used to deny services by disabling all announcement/queries
by using Service Policy IN of type GUI-deny-all and in Service Policy OUT of type GUI-deny-all.
• Custom— You can set your own IN and OUT policy. It allows you to define a custom service list.
Step 4
Click Apply.
Step 5
Click Save Configuration.
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
286 OL-29890-01
Configuring the Service Discovery Gateway
Enabling Multicast DNS Gateway (GUI)