Cisco Catalyst 3650 User Manual

Example Enabling ECMP Multicast Load Splitting Based on Source and Group
Address
The following example shows how to enable ECMP multicast load splitting on a router based on source and
group address using the basic S-G-hash algorithm:
ip multicast multipath s-g-hash basic
Related Topics
Enabling ECMP Multicast Load Splitting Based on Source and Group Address, on page 328
ECMP Multicast Load Splitting Based on Source and Group Address Using the Basic S-G-Hash Algorithm,
on page 317
Example Enabling ECMP Multicast Load Splitting Based on Source Group and
Next-Hop Address
The following example shows how to enable ECMP multicast load splitting on a router based on source,
group, and next-hop address using the next-hop-based S-G-hash algorithm:
ip multicast multipath s-g-hash next-hop-based
Related Topics
Enabling ECMP Multicast Load Splitting Based on Source Group and Next-Hop Address, on page 329
ECMP Multicast Load Splitting Based on Source Group and Next-Hop Address, on page 319
Additional References
Related Documents
Document TitleRelated Topic
Cisco IOS Master Commands List, All Releases
Cisco IOS commands
Cisco IOS IP Multicast Command Reference
Cisco IOS IP Multicast commands
Standards and RFCs
TitleStandard/RFC
Protocol Independent Multicast-Sparse Mode
(PIM-SM): Protocol Specification
RFC 4601
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
332 OL-29890-01
IP Multicast Optimization: IP Multicast Load Splitting across Equal-Cost Paths
Example Enabling ECMP Multicast Load Splitting Based on Source and Group Address

Cisco Catalyst 3650 Specifications

General

Switching Capacity	160 Gbps
Uplink Interfaces	4 x 1G SFP or 2 x 10G SFP+
Device Type	Switch
Form Factor	Rack-mountable
Layer	Layer 3
DRAM	4 GB
Flash Memory	4 GB
Operating System	Cisco IOS XE
Model	Catalyst 3650
Ports	24 or 48 10/100/1000 Ethernet ports
Stacking	Yes
Power over Ethernet (PoE)	Yes
Power Supply Options	350W AC
VLANs	4094