Cisco Catalyst 3650 User Manual

PurposeCommand or Action
Verifies your entries.
show ip igmp interface [interface-id]
Example:
Device# show ip igmp interface
Step 6
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Device# copy running-config
Step 7
startup-config
Changing the IGMP Query Timeout for IGMPv2 (CLI)
If you are using IGMPv2, you can specify the period of time before the device takes over as the querier for
the interface. By default, the device waits twice the query interval period controlled by the ip igmp
query-interval interface configuration command. After that time, if the device has received no queries, it
becomes the querier.
This procedure is optional.
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
interface interface-id
4.
ip igmp querier-timeout seconds
5.
end
6.
show ip igmp interface [interface-id]
7.
copy running-config startup-config
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Device> enable
•
Enter your password if prompted.
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
40 OL-29890-01
Configuring IGMP
Changing the IGMP Query Timeout for IGMPv2 (CLI)

Cisco Catalyst 3650 Specifications

General

Switching Capacity	160 Gbps
Uplink Interfaces	4 x 1G SFP or 2 x 10G SFP+
Device Type	Switch
Form Factor	Rack-mountable
Layer	Layer 3
DRAM	4 GB
Flash Memory	4 GB
Operating System	Cisco IOS XE
Model	Catalyst 3650
Ports	24 or 48 10/100/1000 Ethernet ports
Stacking	Yes
Power over Ethernet (PoE)	Yes
Power Supply Options	350W AC
VLANs	4094