Cisco Catalyst 3650 User Manual

DescriptionCommands
Displays the client-to-SGV mappings and
SGV-to-client mappings.
show ip igmp snooping igmpv2-tracking
Displays IGMP querier information for the specified
VLAN.
show ip igmp snooping querier vlan vlanid
Displays detailed IGMP querier information of all
the VLANs.
show ip igmp snooping querier detail
Displays MLD querier information for the specified
VLAN.
show ipv6 mld snooping querier vlan vlanid
Displays MGIDs for IPv6 multicast group.show ipv6 mld snooping wireless mgid
Where to Go Next for Wireless Multicast
You can configure the following:
•
IGMP
•
PIM
•
SSM
•
IP Multicast Routing
•
Service Discovery Gateway
You can also review the following IP Multicast Optimization processes for your configuration:
•
Optimizing PIM Sparse Mode in a Large IP Multicast Deployment
•
Multicast Subsecond Convergence
•
IP Multicast Load Splitting across Equal-Cost Paths
•
SSM Channel Based Filtering for Multicast
•
PIM Dense Mode State Refresh
•
IGMP State Limit
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
OL-29890-01 227
Configuring Wireless Multicast
Where to Go Next for Wireless Multicast

Cisco Catalyst 3650 Specifications

General

Switching Capacity	160 Gbps
Uplink Interfaces	4 x 1G SFP or 2 x 10G SFP+
Device Type	Switch
Form Factor	Rack-mountable
Layer	Layer 3
DRAM	4 GB
Flash Memory	4 GB
Operating System	Cisco IOS XE
Model	Catalyst 3650
Ports	24 or 48 10/100/1000 Ethernet ports
Stacking	Yes
Power over Ethernet (PoE)	Yes
Power Supply Options	350W AC
VLANs	4094