Cisco Catalyst 3650

CHAPTER 10
Configuring SSM
•
Finding Feature Information, page 231
•
Prerequisites for Configuring SSM, page 231
•
Restrictions for Configuring SSM, page 232
•
Information About SSM, page 233
•
How to Configure SSM, page 237
•
Monitoring SSM, page 245
•
Configuration Examples for Source Specific Multicast, page 246
•
Where to Go Next for SSM, page 247
•
Additional References, page 247
•
Feature History and Information for SSM, page 249
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest feature
information and caveats, see the release notes for your platform and software release.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not
required.
Prerequisites for Configuring SSM
The following are the prerequisites for configuring source-specific multicast (SSM) and SSM mapping:
•
Before you configure SSM mapping, you must perform the following tasks:
◦
Enable IP multicast routing. For information about this procedure, see Configuring Basic IP
Multicast Routing (CLI), on page 256.
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
OL-29890-01 231