Cisco Catalyst 3650

CHAPTER 12
Configuring the Service Discovery Gateway
•
Finding Feature Information, page 275
•
Restrictions for Configuring the Service Discovery Gateway, page 275
•
Information about the Service Discovery Gateway and mDNS, page 276
•
How to Configure the Service Discovery Gateway, page 279
•
Monitoring Service Discovery Gateway, page 287
•
Configuration Examples, page 287
•
Where to Go Next for Configuring Services Discovery Gateway, page 289
•
Additional References, page 290
•
Feature History and Information for Services Discovery Gateway, page 291
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest feature
information and caveats, see the release notes for your platform and software release.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not
required.
Restrictions for Configuring the Service Discovery Gateway
The following are restrictions for configuring the Service Discovery Gateway:
•
The Service Discovery Gateway does not support topologies with multiple hops. All network segments
must be connected directly to it. The Service Discovery Gateway can learn services from all connected
segments to build its cache and respond to requests acting as a proxy.
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
OL-29890-01 275