EasyManua.ls Logo

Cisco Catalyst 3650

Cisco Catalyst 3650
384 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
snmp-server enable traps pim [neighbor-change | rp-mapping-change | invalid-pim-message]
4.
snmp-server host host-address [traps | informs] community-string pim
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Device> enable
Enter your password if prompted.
Enters global configuration mode.configure terminal
Example:
Device# configure terminal
Step 2
Enables a device to send PIM notifications.snmp-server enable traps pim
[neighbor-change | rp-mapping-change |
invalid-pim-message]
Step 3
neighbor-change --This keyword enables notifications indicating
when a devices PIM interface is disabled or enabled, or when a
devices PIM neighbor adjacency expires.
Example:
Device(config)# snmp-server enable traps
pim neighbor-change
rp-mapping-change --This keyword enables notifications
indicating a change in RP mapping information due to either
Auto-RP messages or BSR messages.
invalid-pim-message --This keyword enables notifications for
monitoring invalid PIM protocol operations (for example, when a
device receives a join or prune message for which the RP specified
in the packet is not the RP for the multicast group or when a device
receives a register message from a multicast group for which it is
not the RP).
Specifies the recipient of a PIM SNMP notification operation.
snmp-server host host-address [traps |
informs] community-string pim
Step 4
Example:
Device(config)# snmp-server host
10.10.10.10 traps public pim
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
OL-29890-01 165
Configuring PIM MIB Extension for IP Multicast
Enabling PIM MIB Extensions for IP Multicast

Table of Contents

Other manuals for Cisco Catalyst 3650

Related product manuals