Cisco Catalyst 3650

CHAPTER 14
IP Multicast Optimization: Multicast Subsecond
Convergence
•
Finding Feature Information, page 303
•
Prerequisites for Multicast Subsecond Convergence, page 303
•
Restrictions for Multicast Subsecond Convergence, page 304
•
Information About Multicast Subsecond Convergence, page 304
•
How to Configure Multicast Subsecond Convergence, page 306
•
Configuration Examples for Multicast Subsecond Convergence, page 310
•
Additional References, page 311
•
Feature History and Information for Multicast Subsecond Convergence, page 312
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest feature
information and caveats, see the release notes for your platform and software release.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not
required.
Prerequisites for Multicast Subsecond Convergence
Service providers must have a multicast-enabled core in order to use the Cisco Multicast Subsecond
Convergence feature.
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
OL-29890-01 303