Cisco Catalyst 3650

PurposeCommand or Action
(Optional) Displays the configured IGMP leave time.show ip igmp snooping
Example:
Device# show ip igmp snooping
Step 6
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Device# copy running-config startup-config
Step 7
Related Topics
IGMP Configurable-Leave Timer, on page 31
Configuring the IGMP Robustness-Variable (CLI)
Use the following procedure to configure the IGMP robustness variable on the device.
The robustness variable is the integer used by IGMP snooping during calculations for IGMP messages. The
robustness variable provides fine tuning to allow for expected packet loss.
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
ip igmp snooping robustness-variable count
4.
ip igmp snooping vlan vlan-id robustness-variable count
5.
end
6.
show ip igmp snooping
7.
copy running-config startup-config
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Device> enable
•
Enter your password if prompted.
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
OL-29890-01 67
Configuring IGMP
How to Configure IGMP Snooping