EasyManuals Logo

Cisco Catalyst 3650 User Manual

Cisco Catalyst 3650
384 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #282 background imageLoading...
Page #282 background image
PurposeCommand or Action
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Device# copy running-config
Step 6
startup-config
Related Topics
Multicast Forwarding Information Base Overview , on page 253
Configuring a Static Multicast Route (mroute) (CLI)
You can use the following procedure to configure static mroutes. Static mroutes are similar to unicast static
routes but differ in the following ways:
•
Static mroutes are used to calculate RPF information, not to forward traffic.
•
Static mroutes cannot be redistributed.
Static mroutes are strictly local to the device on which they are defined. Because Protocol Independent Multicast
(PIM) does not have its own routing protocol, there is no mechanism to distribute static mroutes throughout
the network. Consequently, the administration of static mroutes tends to be more complicated than the
administration of unicast static routes.
When static mroutes are configured, they are stored on the device in a separate table referred to as the static
mroute table. When configured, the ip mroute command enters a static mroute into the static mroute table
for the source address or source address range specified for the source-address and mask arguments. Sources
that match the source address or that fall in the source address range specified for the source-address argument
will RPF to either the interface associated with the IP address specified for the rpf-address argument or the
local interface on the device specified for the interface-type and interface-number arguments. If an IP address
is specified for the rpf-address argument, a recursive lookup is done from the unicast routing table on this
address to find the directly connected neighbor.
If there are multiple static mroutes configured, the device performs a longest-match lookup of the mroute
table. When the mroute with the longest match (of the source-address) is found, the search terminates and the
information in the matching static mroute is used. The order in which the static mroutes are configured is not
important.
The administrative distance of an mroute may be specified for the optional distance argument. If a value is
not specified for the distance argument, the distance of the mroute defaults to zero. If the static mroute has
the same distance as another RPF source, the static mroute will take precedence. There are only two exceptions
to this rule: directly connected routes and the default unicast route.
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
260 OL-29890-01
Configuring IP Multicast Routing
Configuring a Static Multicast Route (mroute) (CLI)

Table of Contents

Other manuals for Cisco Catalyst 3650

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 3650 and is the answer not in the manual?

Cisco Catalyst 3650 Specifications

General IconGeneral
Switching Capacity160 Gbps
Uplink Interfaces4 x 1G SFP or 2 x 10G SFP+
Device TypeSwitch
Form FactorRack-mountable
LayerLayer 3
DRAM4 GB
Flash Memory4 GB
Operating SystemCisco IOS XE
ModelCatalyst 3650
Ports24 or 48 10/100/1000 Ethernet ports
StackingYes
Power over Ethernet (PoE)Yes
Power Supply Options350W AC
VLANs4094

Related product manuals