Cisco Catalyst 3650

Router-Port Group Management Protocol (RGMP), on page 103
Where to Go Next for Constraining IP Multicast in Switched
Ethernet
You can configure the following:
•
IGMP
•
PIM
•
SSM
•
IP Multicast Routing
•
Service Discovery Gateway
You can also review the following IP Multicast Optimization processes for your configuration:
•
Optimizing PIM Sparse Mode in a Large IP Multicast Deployment
•
Multicast Subsecond Convergence
•
IP Multicast Load Splitting across Equal-Cost Paths
•
SSM Channel Based Filtering for Multicast
•
PIM Dense Mode State Refresh
•
IGMP State Limit
Additional References
The following sections provide references related to constraining IP multicast in a switched Ethernet network.
Related Documents
Document TitleRelated Topic
Cisco IOS Master Commands List, All Releases
Cisco IOS commands
Cisco IOS IP Multicast Command Reference
Cisco IOS IP SLAs commands
The “IGMP Snooping” module of the IP Multicast:
IGMP Configuration Guide
IGMP snooping
The “Configuring Router-Port Group Management
Protocol” module of the IP Multicast: IGMP
Configuration Guide
RGMP
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
108 OL-29890-01
Constraining IP Multicast in Switched Ethernet
Where to Go Next for Constraining IP Multicast in Switched Ethernet