Cisco Catalyst 3650

CHAPTER 6
Configuring PIM
•
Finding Feature Information, page 111
•
Prerequisites for Configuring PIM, page 111
•
Restrictions for Configuring PIM, page 112
•
Restrictions for Configuring Auto-RP, page 112
•
Restrictions for Configuring Auto-RP and BSR, page 113
•
Information About PIM, page 113
•
How to Configure PIM, page 124
•
Monitoring PIM , page 155
•
Troubleshooting PIMv1 and PIMv2 Interoperability Problems, page 156
•
Configuration Examples for PIM, page 156
•
Where to Go Next for PIM , page 160
•
Additional References, page 160
•
Feature History and Information for PIM, page 162
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest feature
information and caveats, see the release notes for your platform and software release.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not
required.
Prerequisites for Configuring PIM
The following are the prerequisites for configuring PIM and PIM stub routing:
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
OL-29890-01 111