Cisco Catalyst 3650

CHAPTER 15
IP Multicast Optimization: IP Multicast Load
Splitting across Equal-Cost Paths
•
Finding Feature Information, page 313
•
Prerequisites for IP Multicast Load Splitting across Equal-Cost Paths, page 313
•
Information About IP Multicast Load Splitting across Equal-Cost Paths, page 314
•
How to Load Split IP Multicast Traffic over ECMP, page 324
•
Configuration Examples for Load Splitting IP Multicast Traffic over ECMP, page 331
•
Additional References, page 332
•
Feature History and Information for Load Splitting IP Multicast Traffic over ECMP, page 333
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest feature
information and caveats, see the release notes for your platform and software release.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not
required.
Prerequisites for IP Multicast Load Splitting across Equal-Cost
Paths
IP multicast is enabled on the device using the tasks described in the “Configuring Basic IP Multicast” module
of the IP Multicast: PIM Configuration Guide.
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
OL-29890-01 313