Cisco Catalyst 3650

PurposeCommand or Action
Example:
Device(config-if)# ip igmp
proxy-service
•
When the mroute proxy service is enabled, the device periodically
checks the static mroute table for (*, G) forwarding entries that match
interfaces configured with the ip igmp mroute-proxy command (see
Step 7) based on the IGMP query interval. Where there is a match,
one IGMP report is created and received on this interface.
The ip igmp proxy-service command is intended to be used with
the ip igmp helper-address (UDL) command.
Note
•
In this example, the ip igmp proxy-service command is configured
on loopback interface 0 to enable the forwarding of IGMP reports out
the interface for all groups on interfaces registered through the ip
igmp mroute-proxy command (see Step 7).
Ends the current configuration session and returns to privileged EXEC
mode.
end
Example:
Device(config-if)# end
Step 12
(Optional) Displays multicast-related information about an interface.show ip igmp interface
Example:
Device# show ip igmp interface
Step 13
(Optional) Displays UDLR information for directly connected multicast
groups on interfaces that have a UDL helper address configured.
show ip igmp udlr
Example:
Device# show ip igmp udlr
Step 14
Related Topics
IGMP Proxy, on page 90
Example: IGMP Proxy Configuration, on page 96
Configuration Examples for IGMP Proxy
Example: IGMP Proxy Configuration
The following example shows how to configure the upstream UDL device for IGMP UDLR and the downstream
UDL device for IGMP UDLR with IGMP proxy support.
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
96 OL-29890-01
Configuring IGMP Proxy
Configuration Examples for IGMP Proxy