Cisco Catalyst 3650

CHAPTER 7
Configuring PIM MIB Extension for IP Multicast
•
Finding Feature Information, page 163
•
Information About PIM MIB Extension for IP Multicast, page 163
•
How to Configure PIM MIB Extension for IP Multicast, page 164
•
Configuration Examples for PIM MIB Extensions, page 166
•
Additional References, page 166
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest feature
information and caveats, see the release notes for your platform and software release.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not
required.
Information About PIM MIB Extension for IP Multicast
PIM MIB Extensions for SNMP Traps for IP Multicast
Protocol Independent Multicast (PIM) is an IP multicast routing protocol used for routing multicast data
packets to multicast groups. RFC 2934 defines the PIM MIB for IPv4, which describes managed objects that
enable users to remotely monitor and configure PIM using Simple Network Management Protocol (SNMP).
PIM MIB extensions introduce the following new classes of PIM notifications:
•
neighbor-change--This notification results from the following conditions:
• A router’s PIM interface is disabled or enabled (using the ip pim command in interface configuration
mode)
•
A router's PIM neighbor adjacency expires (defined in RFC 2934)
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
OL-29890-01 163