Cisco Catalyst 9500 Series - Page 4

Configuring BFD Support for HSRP 17
Configuring BFD Support for Static Routing 18
Configuring BFD Echo Mode 21
Prerequisites 21
Restrictions 21
Disabling BFD Echo Mode Without Asymmetry 21
Creating and Configuring BFD Templates 22
Configuring a Single-Hop Template 22
Monitoring and Troubleshooting BFD 23
Monitoring and Troubleshooting BFD 23
Feature Information for Bidirectional Forwarding Detection 24
CHAPTER 2 Configuring MSDP 25
Information About Configuring MSDP 25
MSDP Overview 25
MSDP Operation 26
MSDP Benefits 27
How to Configure MSDP 28
Default MSDP Configuration 28
Configuring a Default MSDP Peer 28
Caching Source-Active State 30
Requesting Source Information from an MSDP Peer 31
Controlling Source Information that Your Switch Originates 32
Redistributing Sources 33
Filtering Source-Active Request Messages 35
Controlling Source Information that Your Switch Forwards 36
Using a Filter 36
Using TTL to Limit the Multicast Data Sent in SA Messages 39
Controlling Source Information that Your Switch Receives 40
Configuring an MSDP Mesh Group 42
Shutting Down an MSDP Peer 43
Including a Bordering PIM Dense-Mode Region in MSDP 44
Configuring an Originating Address other than the RP Address 46
Monitoring and Maintaining MSDP 47
Configuration Examples for Configuring MSDP 48
Routing Configuration Guide, Cisco IOS XE Everest 16.6.x (Catalyst 9500 Switches)
iv
Contents