9-18
Cisco CRS-1 Series Carrier Routing System Getting Started Guide
Chapter 9 Troubleshooting the Cisco IOS XR Software
Memory Warnings in Configuration Sessions
The output from this command does not show the details of the entries, but allows you to display a larger
list of the commit events that occurred. To display the commitIDs that you can roll back to, use the show
rollback points command.
RP/0/RP0/CPU0:router# show configuration history
SNo. Label/ID User Line Client Time Stamp
~~~~ ~~~~~~~~ ~~~~ ~~~~ ~~~~~~ ~~~~~~~~~~
1 1000000144 user vty0 CLI 00:16:51 UTC Thu Dec 11 2003
2 1000000143 user vty0 CLI 00:04:32 UTC Thu Dec 11 2003
3 1000000142 user 0.0.0.0 XMLAgent 21:58:36 UTC Wed Dec 10 2003
4 1000000141 user 0.0.0.0 XMLAgent 21:46:07 UTC Wed Dec 10 2003
5 1000000140 lab con0_RP1_C CLI 21:43:30 UTC Wed Dec 10 2003
6 1000000139 user 0.0.0.0 XMLAgent 21:40:13 UTC Wed Dec 10 2003
7 1000000138 user 0.0.0.0 XMLAgent 21:34:48 UTC Wed Dec 10 2003
8 1000000137 lab con0_RP1_C CLI 21:32:10 UTC Wed Dec 10 2003
9 1000000136 user 0.0.0.0 XMLAgent 21:30:13 UTC Wed Dec 10 2003
10 1000000135 lab con0_RP1_C CLI 19:45:04 UTC Wed Dec 10 2003
Step 3 Enter the show commit changes command followed by a commitID number to display the configuration
changes for a commit session (commitID). For example:
RP/0/RP0/CPU0:router# show commit changes 1000000053
Building configuration...
interface preconfigure MgmtEth0/RP1/CPU0/0
ipv4 address 10.8.50.10 255.255.0.0
proxy-arp
!
route ipv4 172.255.254.254/32 12.8.0.1
end
Step 4 Remove the configuration using the appropriate configuration commands. In some situations, the
commit command is not allowed. Users with lr-root access can still use the commit force command, but
this command should be used only to remove configurations. The addition of new configurations will
seriously impact router operation.
For more information, see the “Configuration History and Rollback” section on page 2-23.
To Next Page
Loading...
Need help?
General
