Cisco CRS-1 - Carrier Routing System Router Getting Started Guide

7-4
Cisco CRS-1 Series Carrier Routing System Getting Started Guide
Chapter 7 RP Redundancy and Hardware Administration on Cisco IOS XR Software
Command Syntax for Hardware Nodes (location nodeID)
show version Command
The following is sample output from the show version command:
RP/0/RP0/CPU0:router# show version
Cisco IOS-XR Software, Version 1.0.0
Copyright (c) 2004 by cisco Systems, Inc.
ROM: System Bootstrap, Version 1.15(20040120:002852) ,
router uptime is 2 days, 1 hour, 59 minutes
System image file is "tftp://223.0.0.0/usr/comp-hfr-full.vm-1.0.0
cisco CRS-16/S (7450) processor with 2097152K bytes of memory.
7450 processor at 650Mhz, Implementation , Revision
4 Packet over SONET network interface(s)
4 SONET/SDH Port controller(s)
1 Ethernet/IEEE 802.3 interface(s)
2043k bytes of non-volatile configuration memory.
1000592k bytes of ATA PCMCIA card at disk 0 (Sector size 512 bytes).
Configuration register is 0x0
Package active on node 0/2/SP:
hfr-admin, V 1.0.0, Cisco Systems, at mem:hfr-admin-1.0.0
Built on Fri Mar 5 19:12:26 PST 2004
--More--
Command Syntax for Hardware Nodes (location nodeID)
In the Cisco IOS XR software, many commands require you to identify the “location” of the node to
which actions apply. In the command reference documentation, the syntax for the location is location
nodeID. This nodeID represents the path, through the system, to the module that executes the commands.
This “module” is the CPU or service processor (SP) on the card that executes the commands.
The nodeID argument is entered in the rack/slot/module notation. Figure 7-1 illustrates the node ID
components.

Cisco CRS-1 - Carrier Routing System Router Specifications

General

Brand	Cisco
Model	CRS-1 - Carrier Routing System Router
Category	Network Router
Language	English