Cisco CRS-1 - Carrier Routing System Router Getting Started Guide

5-4
Cisco CRS-1 Series Carrier Routing System Getting Started Guide
Chapter 5 Initial Configuration of the Cisco IOS XR Software
Configuring the Management Ethernet Interface
RP/0/RP0/CPU0:router(config)# interface MgmtEth ?
0/RP0/CPU0/0 MgmtEth Interface Instance
Configuring the Management Ethernet Interface
To use the Management Ethernet interface for system management and remote communication, you must
configure an IP address.
Prerequisites
To configure the Ethernet Management port for network communications, you must enter the interface
network addresses and subnet mask. Consult your network administrator or system planner for this
information.
SUMMARY STEPS
1. configure
2. interface MgmtEth0/slot/CPU0/0
3. ipv4 address ipv4 address subnet-mask
4. no shutdown
5. commit
6. end
7. show interfaces MgmtEth0/slot/CPU0/0

Cisco CRS-1 - Carrier Routing System Router Specifications

General

Brand	Cisco
Model	CRS-1 - Carrier Routing System Router
Category	Network Router
Language	English