6-22
Cisco CRS-1 Series Carrier Routing System Getting Started Guide
Chapter 6 Managing Cisco IOS XR Software Packages
Package Management Procedures
Node 0/RP0/CPU0 [RP]
Boot Image: /disk0/hfr-os-mbi-1.0.0/mbihfr-rp.vm
Active Packages:
disk0:hfr-mgbl-1.0.0
disk0:hfr-mpls-1.0.0
disk0:hfr-mcast-1.0.0
disk0:hfr-rout-1.0.0
disk0:hfr-lc-1.0.0
disk0:hfr-fwdg-1.0.0
disk0:hfr-admin-1.0.0
disk0:hfr-base-1.0.0
disk0:hfr-os-mbi-1.0.0
Node 0/SM0/SP [SP]
Boot Image: /disk0/hfr-os-mbi-1.0.0/sp/mbihfr-sp.vm
Active Packages:
disk0:hfr-admin-1.0.0
disk0:hfr-base-1.0.0
disk0:hfr-os-mbi-1.0.0
Displaying the Active Packages for a Single Card
Enter the show install active command to verify that the correct packages are active on each card (node).
The following example shows the active packages on a single node (card):
RP/0/RP0/CPU0:router# show install active location 0/1/cpu0
Node 0/1/CPU0 [LC]
Boot Image: /disk0/hfr-os-mbi-1.0.0/lc/mbihfr-lc.vm
Active Packages:
disk0:hfr-mpls-1.0.0
disk0:hfr-mcast-1.0.0
disk0:hfr-lc-1.0.0
disk0:hfr-fwdg-1.0.0
disk0:hfr-admin-1.0.0
disk0:hfr-base-1.0.0
disk0:hfr-os-mbi-1.0.0
Copying, Adding, and Activating Packages
You can copy a package file to the router, add the package file, and activate the package by using a
separate command for each task or by using a single command for all tasks. The following sections
introduce the file transfer protocols you can use and show the commands to copy, add, and activate
software packages:
• Controlling install Command Operation, page 6-23
• Supported File Transfer Protocols, page 6-23
• Copying Package Files from a Network Server to the Router, page 6-23
• Adding Packages that are Resident on the Router, page 6-25
• Copying and Adding Files in One Step from a Network Server, page 6-25
• Activating a Package for All Appropriate Cards, page 6-26
• Activating a Package for a Single Card, page 6-26
• Copying, Adding, and Activating Package Files in One Step from a Network Server, page 6-26
To Next Page
Loading...
Need help?
General
