EasyManuals Logo

Cisco CRS-1 - Carrier Routing System Router Getting Started Guide

Cisco CRS-1 - Carrier Routing System Router
289 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #96 background imageLoading...
Page #96 background image
5-2
Cisco CRS-1 Series Carrier Routing System Getting Started Guide
Chapter 5 Initial Configuration of the Cisco IOS XR Software
Configuring the Management Ethernet Interface
3. commit
Example
The following example, shows how to configure the hostname for the router:
RP/0/RP0/CPU0:router# configure
RP/0/RP0/CPU0:router(config)# hostname new_name
RP/0/RP0/CPU0:router(config)# commit
RP/0/RP0/CPU0:Apr 7 00:07:33.246 : config[65669]: %LIBTARCFG-6-COMMIT : Configu
ration committed by user 'user_a'. Use 'show commit changes 1000000067' to view t
he changes.
RP/0/RP0/CPU0:new_name(config)#
Note No blanks or spaces are permitted as part of a name. Do not expect case to be preserved. Upper- and
lowercase characters look the same to many Internet software applications. It may seem appropriate to
capitalize a name the same way you might if you were writing, but conventions dictate that computer
names appear all lowercase. For more information, refer to RFC 1178, Choosing a Name for Your
Computer.
Configuring the Management Ethernet Interface
The Management Ethernet (MgmtEth) interface on the Route Processors (RPs) is used to connect the
router to a network for remote management using a Telnet client, the Craft Works Interface (CWI), the
Simple Network Management Protocol (SNMP), or other management agents. The following sections
provide information on the Management Ethernet interface:
“Specifying the Management Ethernet Interface in CLI Commands”
“Displaying the Available Management Ethernet Instance”
“Configuring the Management Ethernet Interface”
Specifying the Management Ethernet Interface in CLI Commands
To configure the Management Ethernet interface, you must enter the interface configuration mode, and
identify the location of the Management Ethernet interface instance, where instance is defined as type
rack/slot/module/port. Table 5-1 describes the instance syntax.
Table 5-1 Instance Syntax Description
Syntax Components Description
type Interface type for a Management Ethernet port is “MgmtEth.”
rack Chassis number of the rack. In a single-chassis system, the rack is
always “0.”

Table of Contents

Other manuals for Cisco CRS-1 - Carrier Routing System Router

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco CRS-1 - Carrier Routing System Router and is the answer not in the manual?

Cisco CRS-1 - Carrier Routing System Router Specifications

General IconGeneral
BrandCisco
ModelCRS-1 - Carrier Routing System Router
CategoryNetwork Router
LanguageEnglish

Related product manuals