Cisco CRS-1 - Carrier Routing System Router Getting Started Guide

9-13
Cisco CRS-1 Series Carrier Routing System Getting Started Guide
Chapter 9 Troubleshooting the Cisco IOS XR Software
Configuration Error Messages
Table 9-9 Commands to Manage Processes
Configuration Error Messages
The following sections contain information on configuration error messages:
• Configuration Failures During a Commit Operation, page 9-13
• Configuration Errors at Startup, page 9-14
Configuration Failures During a Commit Operation
A target configuration is added to the running configuration of a router when the commit command is
entered. During this operation, the changes are automatically verified by the other components in the
system. If successful, the configuration becomes part of the running configuration. If some configuration
items fail, an error message is returned.
To display the configuration items that failed and see the cause of each failure, enter the show
configuration failed command.
Note The show configuration failed command can be entered in either the EXEC mode or any configuration
mode. In any mode, the configuration failures from the most recent commit operation are displayed.
1. In the following example, a configuration error occurs when an invalid commit operation is
attempted:
RP/0/RP0/CPU0:router# configure
RP/0/RP0/CPU0:router(config)# taskgroup bgp
RP/0/RP0/CPU0:router(config-tg)# description this is a test of an invalid taskgroup
RP/0/RP0/CPU0:router(config-tg)# commit
% Failed to commit one or more configuration items. Please use 'show configurati
on failed' to view the errors
2. To display the configuration items that failed, including a description of the error, enter the
show configuration failed command:
RP/0/RP0/CPU0:router(config-tg)# show configuration failed
!! CONFIGURATION FAILED DUE TO SEMANTIC ERRORS
taskgroup bgp
!!% Usergroup/Taskgroup names cannot be taskid names
!
Command Description
process {kill | restart | start} Manually stops, starts, or restarts a process or process
instance.
process mandatory {on | off} Changes the mandatory setting for a process.
process mandatory reboot {enable | disable} Changes how the system reacts to mandatory processes that
go down.

Cisco CRS-1 - Carrier Routing System Router Specifications

General

Brand	Cisco
Model	CRS-1 - Carrier Routing System Router
Category	Network Router
Language	English