Cisco CRS-1 - Carrier Routing System Router Getting Started Guide

CHAPTER
5-1
Cisco CRS-1 Series Carrier Routing System Getting Started Guide
5
Initial Configuration of the Cisco IOS XR Software
This chapter contains instructions and information for entering basic configurations using the
command-line interface (CLI). For information on entering basic configurations using the on-screen
prompts, see the “Entering the Initial Configuration Using the Setup Mode Prompts” section on
page 4-5.
Contents
This chapter contains the following sections:
• Configuring the Router Hostname, page 5-1
• Configuring the Management Ethernet Interface, page 5-2
• Configuring the Domain Name and Domain Name Server, page 5-6
• Configuring Telnet, HTTP, and XML Host Services, page 5-7
• Installing the Optional Craft Works Interface, page 5-8
• Manually Setting the Router Clock, page 5-9
• Configuring Logging and Logging Correlation, page 5-11
• Creating and Modifying User Accounts and User Groups, page 5-14
• Configuration Limiting, page 5-18
Configuring the Router Hostname
The hostname identifies a router on the network. Although devices can be uniquely identified by their
Layer 2 and Layer 3 addresses (such as an IP address), it is often simpler to remember network devices
by a alphanumeric “hostname.” This name is used in the CLI prompt, in default configuration filenames,
and to identify the router on the network.
To configure the hostname, enter the hostname command followed by the name of the router in global
configuration mode.
SUMMARY STEPS
1. configure
2. hostname router-name

Cisco CRS-1 - Carrier Routing System Router Specifications

General

Brand	Cisco
Model	CRS-1 - Carrier Routing System Router
Category	Network Router
Language	English