7-3
Cisco CRS-1 Series Carrier Routing System Getting Started Guide
Chapter 7 RP Redundancy and Hardware Administration on Cisco IOS XR Software
Commands to Display Hardware Status
show platform Command
The following is sample output from the show platform command for all nodes in a router:
RP/0/RP0/CPU0:router# show platform
Node Type PLIM State Config State
-----------------------------------------------------------------------------
0/0/SP MSC(SP) N/A IOS-XR RUN PWR,NSHUT,MON
0/0/CPU0 MSC 16OC48-POS/DPT IOS-XR RUN PWR,NSHUT,MON
0/2/SP MSC(SP) N/A IOS-XR RUN PWR,NSHUT,MON
0/2/CPU0 MSC 16OC48-POS/DPT IOS-XR RUN PWR,NSHUT,MON
0/RP0/CPU0 RP(Standby) N/A IOS-XR RUN PWR,NSHUT,MON
0/RP1/CPU0 RP(Active) N/A IOS-XR RUN PWR,NSHUT,MON
0/SM0/SP FC/S(SP) N/A IOS-XR RUN PWR,NSHUT,MON
show environment Command
In the following example, the LED status of the nodes in the router is shown:
RP/0/RP0/CPU0:router# show environment leds
0/2/*: Module (host) LED status says: OK
0/2/*: Module (plimasic) LED status says: OK
0/SM0/*: Module (host) LED status says: OK
show redundancy Command
In the following example, the output shows the show redundancy command used to display redundancy
status for a redundant pair:
RP/0/RP0/CPU0:router# show redundancy
This node (0/RP0/CPU0) is in ACTIVE role
Partner node (0/RP1/CPU0) is in STANDBY role
Standby node in 0/RP1/CPU0 is ready
Reload and boot info
----------------------
RP reloaded Fri Apr 9 03:44:28 2004: 16 hours, 51 minutes ago
This node booted Fri Apr 9 06:19:05 2004: 14 hours, 16 minutes ago
Last switch-over Fri Apr 9 06:53:18 2004: 13 hours, 42 minutes ago
Standby node boot Fri Apr 9 06:54:25 2004: 13 hours, 41 minutes ago
Standby node last not ready Fri Apr 9 20:35:23 2004: 0 minutes ago
Standby node last ready Fri Apr 9 20:35:23 2004: 0 minutes ago
There have been 2 switch-overs since reload
To Next Page
Loading...
Need help?
General
