Cisco CRS-1 - Carrier Routing System Router Getting Started Guide

7-18
Cisco CRS-1 Series Carrier Routing System Getting Started Guide
Chapter 7 RP Redundancy and Hardware Administration on Cisco IOS XR Software
Configure Routing Interfaces
Examples
In the following example, a POS interface is configured with an IP address:
RP/0/RP0/CPU0:router# configure
RP/0/RP0/CPU0:router(config)# interface pos 0/2/0/0
RP/0/RP0/CPU0:router(config-if)# ipv4 address 10.1.1.1/8
RP/0/RP0/CPU0:router(config-if)# no shutdown
RP/0/RP0/CPU0:router(config-if)# commit
RP/0/RP0/CPU0:router(config-if)# end
RP/0/RP0/CPU0:router# show interfaces pos 0/2/0/0
POS0/2/0/0 is up, line protocol is up (looped)
Hardware is Packet over SONET
Description: faq
Internet address is 10.1.1.1/8
MTU 4474 bytes, BW 2488320 Kbit
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation HDLC, crc 32, controller loopback not set, keepalive set (10 sec
)
Last clearing of "show interface" counters never
30 second input rate 0 bits/sec, 0 packets/sec
30 second output rate 0 bits/sec, 0 packets/sec
11 packets input, 234 bytes, 0 total input drops
0 drops for unrecognized upper-level protocol
Received 0 broadcast packets, 0 multicast packets
0 runts, 0 giants, 0 throttles, 0 parity
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
11 packets output, 234 bytes, 0 total output drops
Output 0 broadcast packets, 0 multicast packets
0 output errors, 0 underruns, 0 applique, 0 resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
Related Documents
Related Topic Document Title
Detailed technical descriptions of the hardware
components for the Cisco CRS-1 router
Cisco CRS-1 Series Carrier Routing System 16-Slot Line Card
Chassis Description
Instructions to install the chassis and related cards Installing the Cisco CRS-1 Series Carrier Routing System 16-Slot
Line Card Chassis
Instructions to replace a POS PLIM card Replacing a Cisco CRS-1 Series Carrier Routing System
Packet-over-SONET Physical Layer Interface Module (PLIM)
Instructions to replace a MSC card Replacing a Cisco CRS-1 Series Carrier Routing System 16-Slot
Line Card Chassis Modular Services Card (MSC)
Complete interface configuration and management
instructions
Cisco IOS XR Interface and Hardware Component Configuration
Guide
Command reference to configure physical and virtual
interfaces
Cisco IOS XR Interface and Hardware Component Command
Reference
Activating, upgrading, or downgrading the line card
software package of Cisco IOS XR software
Chapter 6, “Managing Cisco IOS XR Software Packages”
Instructions and commands to configure IP services on
an interface
Cisco IOS XR IP Addresses and Services Command Reference and
Cisco IOS XR IP Addresses and Services Conf
iguration Guide
Complete list of the documentation available to
configure routing and other services
See the “Related Documents” section on page xii.

Cisco CRS-1 - Carrier Routing System Router Specifications

General

Brand	Cisco
Model	CRS-1 - Carrier Routing System Router
Category	Network Router
Language	English