Cisco CRS-1 - Carrier Routing System Router Getting Started Guide

4-9
Cisco CRS-1 Series Carrier Routing System Getting Started Guide
Chapter 4 Bringing up a New Cisco CRS-1 Router
Bringing Up a Single-Chassis System for the First Time
Verifying the System After Initial Bring Up
Perform the following procedure to verify the status of the router.
SUMMARY STEPS
1. show version
2. show platform node-id
3. show redundancy
4. show environment
DETAILED STEPS
Examples of show Commands
The following sections provide examples of show commands:
• show version Command, page 4-10
• show environment Command, page 4-10
• show platform Command, page 4-11
• show redundancy Command, page 4-12
Command or Action Purpose
Step 1
show version
RP/0/RP0/CPU0:router# show version
Displays information about the router, including image
names, up time, and other system information.
Step 2
show platform
RP/0/RP0/CPU0:router# show platform
Displays information about the status of cards and modules
installed in the router.
• Type the show platform nodeId command to display
information for a specific node.
Step 3
show redundancy
Example:
RP/0/RP0/CPU0:router# show redundancy
Displays the state of the primary (active) and standby
(inactive) RPs, including the ability of the standby to take
control of the system.
Step 4
show environment
Example:
RP/0/RP0/CPU0:router# show environment
Displays information about the hardware attributes and
status.

Cisco CRS-1 - Carrier Routing System Router Specifications

General

Brand	Cisco
Model	CRS-1 - Carrier Routing System Router
Category	Network Router
Language	English