Cisco CRS-1 - Carrier Routing System Router Getting Started Guide

5-6
Cisco CRS-1 Series Carrier Routing System Getting Started Guide
Chapter 5 Initial Configuration of the Cisco IOS XR Software
Configuring the Domain Name and Domain Name Server
Examples
In the following example, the Management Ethernet interface on the RP in slot RP1 is configured with
an IP address:
RP/0/RP0/CPU0:router# configure
RP/0/RP0/CPU0:router(config)# interface MgmtEth0/RP1/CPU0/0
RP/0/RP0/CPU0:router(config-if)# ipv4 address 10.1.1.1 255.255.255.0
RP/0/RP0/CPU0:router (config-if)# no shutdown
RP/0/RP0/CPU0:router (config-if)# commit
RP/0/RP0/CPU0:router (config-if)# end
RP/0/RP0/CPU0:router#
RP/0/RP0/CPU0:router# show interfaces MgmtEth 0/RP1/CPU0/0
MgmtEth0/RP1/CPU0/0 is up, line protocol is up
Hardware is Management Ethernet, address is 0005.9a39.910c (bia 0005.9a39.910c
)
Internet address is 10.1.1.1
MTU 1514 bytes, BW 100000 Kbit
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA,
Full-duplex, 100Mb/s
loopback not set
ARP type ARPA, ARP timeout 01:00:00
Last clearing of "show interface" counters never
30 second input rate 0 bits/sec, 0 packets/sec
30 second output rate 0 bits/sec, 0 packets/sec
15205 packets input, 7467959 bytes, 0 total input drops
0 drops for unrecognized upper-level protocol
Received 2352 broadcast packets, 0 multicast packets
0 runts, 0 giants, 0 throttles, 0 parity
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
13528 packets output, 656060 bytes, 0 total output drops
Output 56 broadcast packets, 0 multicast packets
0 output errors, 0 underruns, 0 applique, 0 resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
--More--
Related Documents
Configuring the Domain Name and Domain Name Server
Configure a domain name and domain name server (DNS) for your router to make contacting other
devices on your network more efficient. Use the following guidelines:
• To define a default domain name that the Cisco IOS XR software uses to complete unqualified
hostnames (names without a dotted-decimal domain name), use the domain-name command in
global configuration mode.
Related Topic Document Title
Additional information on configuring management
interfaces
Cisco IOS XR Interface and Hardware Component Configuration
Guide

Cisco CRS-1 - Carrier Routing System Router Specifications

General

Brand	Cisco
Model	CRS-1 - Carrier Routing System Router
Category	Network Router
Language	English