Index
IN-5
Cisco CRS-1 Series Carrier Routing System Getting Started Guide
L
Line Card package features 6-9
line wrap, editing long lines 3-5
logging
alarm correlation
5-12
configuration 5-12
output locations 5-11
severity levels 5-12
logging buffered command 5-11, 5-13
logging command 5-13
logging console command 5-11, 5-13
logging monitor command 5-11
logging trap command 5-11, 5-13
logical router 1-3
log in, router 2-4
long lines, editing 3-5
low memory warning, removing configurations 9-17
M
Manageability package features 6-3
Management Ethernet interface
configuring
5-2
connection illustration (16-slot chassis) 2-2
connection illustration (8-slot chassis) 2-3
displaying 5-3
maximum external-sa command 5-26
maximum group-mappings autorp command 5-26
maximum groups command 5-25
maximum groups per-interface command 5-25
maximum interfaces command 5-21
maximum-paths command (BGP) 5-23
maximum-paths command (IS-IS) 5-20
maximum paths command (OSPF) 5-21
maximum peer-external-sa command 5-26
maximum-prefix command 5-23
maximum redistributed-prefix command (OSPF) 5-21
maximum-redistributed-prefixes command (IS-IS) 5-20
maximum register-states command 5-26
maximum route-interfaces command 5-26
maximum routes command 5-26
memory
displaying system memory
9-16
low memory warnings 9-15
management 5-18
removing configurations 9-17
merged configuration, displaying 2-16, 2-17
modem connection
illustration (16-slot chassis)
2-2
illustration (8-slot chassis) 2-3
modular services card See MSC
module
7-5
module, number displayed in prompt 2-5
monitor processes command 9-7, 9-11
monitor threads command 9-7
More prompt 3-7
MPLS
configuration limits
5-26
package features 6-4
mpls traffic-eng maximum tunnels command 5-26
MSC
overview
1-6
total count 1-3
multicast, configuration limits 5-25
Multicast package features 6-5
N
name
router, configuring
5-1
router name displayed in prompt 2-5
netadmin user group 2-6, 5-16
network connection, overview 2-2
no, command form 3-4
To Next Page
Loading...
Need help?
General
