distribution count
To set the number of statistics distributions that are kept for each hop during the lifetime of the IP SLA
operation, use the distribution count command in IP SLA operation statistics configuration mode. To use
the default value, use the no form of this command.
distribution count slot
no distribution count
Syntax Description
Number of statistics distributions that are kept. Range is 1 to 20. Default is 1.slot
Command Default
The default value is 1.
Command Modes
IP SLA operation statistics configuration
Command History
ModificationRelease
This command was introduced.Release 3.3.0
Usage Guidelines
In most situations, you do not need to change the number of statistics distributions kept or the time interval
for each distribution. Only change these parameters when distributions are needed, for example, when
performing statistical modeling of your network. To set the statistics distributions interval, use the distribution
interval command in IP SLA operation statistics configuration mode. The total number of statistics distributions
captured is the value set by the distribution count command times the value set by the maximum hops
command times the value set by the maximum path command times the value set by the buckets command.
Task ID
OperationsTask ID
read, writemonitor
Examples
The following example shows how to set the number of statistics distribution for the distribution count
command:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# ipsla
RP/0/0/CPU0:router(config-ipsla)# operation 1
RP/0/0/CPU0:router(config-ipsla-op)# type udp jitter
RP/0/0/CPU0:router(config-ipsla-udp-jitter)# statistics hourly
RP/0/0/CPU0:router(config-ipsla-op-stats)# distribution count 15
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
134 OL-24735-01
IP Service Level Agreement Commands
distribution count
To Next Page
Loading...
Need help?
General
