Cisco XR 1200 series User Manual

path discover
To enable path discovery and enter MPLS LSP monitor (MPLSLM) LPD submode, use the path discover
command in IP SLA MPLS LSP monitor ping configuration mode. To use the default value, use the no form
of this command.
path discover
no path discover
Syntax Description
None
Command Default
No default behavior or values
Command Modes
IP SLA MPLS LSP monitor ping configuration
Command History
ModificationRelease
This command was introduced.Release 3.6.0
Usage Guidelines
Task ID
OperationsTask ID
read, writemonitor
Examples
The following example shows how to enter path discover submode:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# ipsla
RP/0/0/CPU0:router(config-ipsla)# mpls lsp-monitor
RP/0/0/CPU0:router(config-ipsla-mplslm)# monitor 1
RP/0/0/CPU0:router(config-ipsla-mplslm-def)# type mpls lsp ping
RP/0/0/CPU0:router(config-ipsla-mplslm-lsp-ping)# path discover
RP/0/0/CPU0:router(config-ipsla-mplslm-lpd)#
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
OL-24735-01 183
IP Service Level Agreement Commands
path discover

Cisco XR 1200 series Specifications

General

Brand	Cisco
Model	XR 1200 series
Category	Network Router
Language	English