Cisco XR 1200 series User Manual

lives
To set the number of lives that are maintained in the history table for an IP SLA operation, use the lives
command in IP SLA operation history configuration mode. To use the default value, use the no form of this
command.
lives lives
no lives
Syntax Description
Number of lives that are maintained in the history table for an IP SLA operation.
Range is 0 to 2.
lives
Command Default
The default value is 0 lives.
Command Modes
IP SLA operation history configuration
Command History
ModificationRelease
This command was introduced.Release 3.3.0
Usage Guidelines
The lives command is supported only to configure the following operations:
•
IP SLA ICMP path-echo
•
IP SLA ICMP echo
•
IP SLA UDP echo
If you use the no form of the lives command, the history statistics are not collected.
Task ID
OperationsTask ID
read, writemonitor
Examples
The following example shows how to use the lives command in IP SLA UDP echo configuration mode:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# ipsla
RP/0/0/CPU0:router(config-ipsla)# operation 1
RP/0/0/CPU0:router(config-ipsla-op)# type udp echo
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
156 OL-24735-01
IP Service Level Agreement Commands
lives

Cisco XR 1200 series Specifications

General

Brand	Cisco
Model	XR 1200 series
Category	Network Router
Language	English