Cisco XR 1200 series User Manual

source port
To identify the port of the source device, use the source port command in the appropriate configuration mode.
To use the unused port number, use the no form of this command.
source port port
no source port
Syntax Description
Identifies the port number of the source device. Range is 1 to 65535.
port port
Command Default
IP SLA uses an unused port that is allocated by system.
Command History
ModificationReleas
This command was introduced.Release 3.3.0
Usage Guidelines
The source port command is not supported to configure ICMP operations; it is supported only to configure
UDP operations.
Task ID
OperationsTask ID
read, writemonitor
Examples
The following example shows how to designate a port for the source port command in IP SLA UDP jitter
configuration mode:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# ipsla
RP/0/0/CPU0:router(config-ipsla)# operation 1
RP/0/0/CPU0:router(config-ipsla-op)# type udp jitter
RP/0/0/CPU0:router(config-ipsla-udp-jitter)# source port 11111
Related Commands
DescriptionCommand
Configures an IP SLA operation.operation, on page 174
Schedules an IP SLA operation.schedule operation, on page 215
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
252 OL-24735-01
IP Service Level Agreement Commands
source port

Cisco XR 1200 series Specifications

General

Brand	Cisco
Model	XR 1200 series
Category	Network Router
Language	English