Cisco XR 1200 series User Manual

maximum paths (IP SLA)
To set the number of paths in which statistics are maintained for each hour for an IP SLA operation, use the
maximum paths command in IP SLA operation statistics configuration mode. To use the default value, use
the no form of this command.
maximum paths paths
no maximum paths
Syntax Description
Number of paths for which statistics are maintained for each hour. Range is 1 to 128.
Default value is 5 for path operations; for example, pathecho.
paths
Command Default
The default value is 5 paths.
Command Modes
IP SLA operation statistics configuration
Command History
ModificationRelease
This command was introduced.Release 3.3.0
Usage Guidelines
The maximum paths command is supported only when you configure path operations and the IP SLA ICMP
path-echo operation.
Task ID
OperationsTask ID
read, writemonitor
Examples
The following example shows how to set the number of paths for the statistics for the maximum paths
command:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# ipsla
RP/0/0/CPU0:router(config-ipsla)# operation 1
RP/0/0/CPU0:router(config-ipsla-op)# type icmp path-echo
RP/0/0/CPU0:router(config-ipsla-icmp-path-echo)# statistics hourly
RP/0/0/CPU0:router(config-ipsla-op-stats)# maximum paths 20
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
166 OL-24735-01
IP Service Level Agreement Commands
maximum paths (IP SLA)

Cisco XR 1200 series Specifications

General

Brand	Cisco
Model	XR 1200 series
Category	Network Router
Language	English