Cisco XR 1200 series User Manual

packet count
To specify the number of packets that are to be transmitted during a probe, such as a sequence of packets
being transmitted for a jitter probe, use the packet count command in the appropriate configuration mode.
To use the default value, use the no form of this command.
packet count count
no packet count
Syntax Description
Number of packets to be transmitted in each operation. Range for a UDP jitter operation
is 1 to 60000. Range for an ICMP path-jitter operation is 1 to 100.
count
Command Default
The default packet count is 10.
Command Modes
IP SLA UDP jitter configuration
IP SLA ICMP path-jitter configuration
Command History
ModificationRelease
This command was introduced.Release 3.3.0
Usage Guidelines
Task ID
OperationsTask ID
read, writemonitor
Examples
The following example shows how to use the packet count command:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# ipsla
RP/0/0/CPU0:router(config-ipsla)# operation 1
RP/0/0/CPU0:router(config-ipsla-op)# type udp jitter
RP/0/0/CPU0:router(config-ipsla-udp-jitter)# packet count 30
Related Commands
DescriptionCommand
Configures an IP SLA operation.operation, on page 174
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
OL-24735-01 179
IP Service Level Agreement Commands
packet count

Cisco XR 1200 series Specifications

General

Brand	Cisco
Model	XR 1200 series
Category	Network Router
Language	English