Cisco XR 1200 series

monitor
To configure an MPLS LSP monitor instance, use the monitor command in IP SLA LSP monitor configuration
mode. To remove the monitor instance, use the no form of this command.
monitor monitor-id
no monitor [ monitor-id ]
Syntax Description
Number of the IP SLA LSP monitor instance to be configured. Range is 1 to
2048.
monitor-id
Command Default
No monitor instance is configured.
Command Modes
IP SLA LSP monitor configuration
Command History
ModificationRelease
This command was introduced.Release 3.5.0
Usage Guidelines
The monitor command enters IP SLA MPLS LSP monitor configuration mode so that you can set the desired
monitor type for all operations associated with the monitored provider edge (PE) routers.
To remove all monitor instances, use the no monitor command with no argument.
Task ID
OperationsTask ID
read, writemonitor
Examples
The following example shows how to use the monitor command:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# ipsla
RP/0/0/CPU0:router(config-ipsla)# mpls lsp-monitor
RP/0/0/CPU0:router(config-ipsla-mplslm)# monitor 1
RP/0/0/CPU0:router(config-ipsla-mplslm-def)#
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
168 OL-24735-01
IP Service Level Agreement Commands
monitor