Cisco XR 1200 series

react lpd
To specify that a reaction should occur if there is an LSP Path Discovery (LPD) violation, use the react lpd
command in the appropriate configuration mode. To use the default value, use the no form of this command.
react lpd {lpd-group| tree-trace} action logging
no react lpd {lpd-group| tree-trace}
Syntax Description
Specifies that a reaction should occur if there is a status violation for the
monitored LPD group.
lpd-group
Specifies that a reaction should occur if there is a path discovery violation for
the monitored LPD group.
tree-trace
Configures the action to be taken on threshold violation.action
Specifies the generation of a syslog alarm on threshold violation.logging
Command Default
None
Command Modes
IP SLA MPLS LSP monitor configuration
Command History
ModificationRelease
This command was introduced.Release 3.6.0
Usage Guidelines
A status violation for a monitored LPD group happens when the Label Switched Path (LSP) group status
changes (with the exception of the status change from the initial state).
A path discovery violation for the monitored LPD group happens when path discovery to the target PE fails,
or successful path discovery clears such a failure condition.
Task ID
OperationsTask ID
read, writemonitor
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
OL-24735-01 195
IP Service Level Agreement Commands
react lpd