Embedded Event Manager Commands
This module describes the commands that are used to set the Embedded Event Manager (EEM) operational
attributes and monitor EEM operations.
The Cisco IOS XR software EEM functions as the central clearing house for the events detected by any
portion of Cisco IOS XR software High Availability Services. The EEM is responsible for fault detection,
fault recovery, and process the reliability statistics in a system. The EEM is policy driven and enables you
to configure the high-availability monitoring features of the system to fit your needs.
The EEM monitors the reliability rates achieved by each process in the system. You can use these metrics
during testing to identify the components that do not meet their reliability or availability goals, which in turn
enables you to take corrective action.
For detailed information about the EEM concepts, configuration tasks, and examples, see the Configuring
and Managing Embedded Event Manager Policies module in Cisco IOS XR System Monitoring Configuration
Guide for the Cisco XR 12000 Series Router.
•
event manager directory user, page 78
•
event manager environment, page 80
•
event manager policy, page 82
•
event manager refresh-time, page 85
•
event manager run, page 86
•
event manager scheduler suspend, page 88
•
show event manager directory user, page 90
•
show event manager environment, page 92
•
show event manager metric hardware , page 94
•
show event manager metric process, page 96
•
show event manager policy available, page 100
•
show event manager policy registered, page 102
•
show event manager refresh-time, page 105
•
show event manager statistics-table, page 107
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
OL-24735-01 77
To Next Page
Loading...
