Cisco XR 1200 series User Manual

distribution interval
To set the time interval (in milliseconds) for each statistical distribution, use the distribution interval command
in IP SLA operation statistics configuration mode. To use the default value, use the no form of this command.
distribution interval interval
no distribution interval
Syntax Description
Number of milliseconds used for each statistics distribution that is kept. Range is
1 to 100. Default is 20.
interval
Command Default
The default value is 20.
Command Modes
IP SLA operation statistics configuration
Command History
ModificationRelease
This command was introduced.Release 3.3.0
Usage Guidelines
In most situations, you do not need to change the number of statistics distributions kept or the time interval
for each distribution. Only change these parameters when distributions are needed, for example, when
performing statistical modeling of your network. To set the statistics distributions count, use the distribution
count command in IP SLA operation statistics configuration mode. The total number of statistics distributions
captured is the value set by the distribution count command times the value set by the maximum hops
command times the value set by the maximum path command times the value set by the buckets command.
Task ID
OperationsTask ID
read, writemonitor
Examples
The following example shows how to set the time interval for the distribution interval command:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# ipsla
RP/0/0/CPU0:router(config-ipsla)# operation 1
RP/0/0/CPU0:router(config-ipsla-op)# type udp jitter
RP/0/0/CPU0:router(config-ipsla-udp-jitter)# statistics hourly
RP/0/0/CPU0:router(config-ipsla-op-stats)# distribution interval 50
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
136 OL-24735-01
IP Service Level Agreement Commands
distribution interval

Cisco XR 1200 series Specifications

General

Brand	Cisco
Model	XR 1200 series
Category	Network Router
Language	English