Cisco XR 1200 series User Manual

source
To apply a logging suppression rule to alarms originating from a specific node on the router, use the source
command in logging suppression apply rule configuration mode.
source location node-id
no source location node-id
Syntax Description
Specifies a node. The node-id argument is entered in the rack/slot/module
notation.
location node-id
Command Default
No scope is configured by default.
Command Modes
Logging suppression apply rule configuration
Command History
ModificationRelease
This command was introduced.Release 3.8.0
Usage Guidelines
Task ID
OperationsTask ID
executelogging
Examples
This example shows how to configure the logging suppression rule infobistate to suppress alarms from
0/RP0/CPU0:
RP/0/0/CPU0:router(config)# logging suppress apply rule infobistate
RP/0/0/CPU0:router(config-suppr-apply-rule)# source location 0/RP0/CPU0
Related Commands
DescriptionCommand
Applies and activates a logging suppression rule.logging suppress apply rule, on page 35
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
OL-24735-01 71
Alarm Management and Logging Correlation Commands
source

Cisco XR 1200 series Specifications

General

Brand	Cisco
Model	XR 1200 series
Category	Network Router
Language	English