Cisco XR 1200 series User Manual

logging trap
To specify the severity level of messages logged to system logging (syslog) servers, use the logging trap
command in global configuration mode. To restore the default behavior, use the no form of this command.
logging trap [ severity ]
no logging trap
Syntax Description
(Optional) Severity level of messages logged to the syslog servers, including events of a
higher severity level (numerically lower). The default is informational. Settings for the
severity levels and their respective system conditions are listed under Table 29: Severity
Levels for Messages, on page 312 in the “Usage Guidelines” section for the logging buffered
command.
severity
Command Default
severity: informational
Command Modes
Global configuration
Command History
ModificationRelease
This command was introduced.Release 3.2
Usage Guidelines
Use the logging trap command to limit the logging of messages sent to syslog servers to only those messages
at the specified level.
Table 29: Severity Levels for Messages, on page 312 under the “Usage Guidelines” section for the logging
buffered, on page 312 command lists the syslog definitions that correspond to the debugging message levels.
Use the logging, on page 308 command to specify a syslog server host as a destination for syslog messages.
Task ID
OperationsTask ID
read, writelogging
Examples
This example shows how to restrict messages to notifications (5) and numerically lower levels.
RP/0/0/CPU0:router(config)# logging trap notifications
Cisco IOS XR System Monitoring Command Reference for the Cisco XR 12000 Series Router, Release 4.1
OL-24735-01 339
Logging Services Commands
logging trap

Cisco XR 1200 series Specifications

General

Brand	Cisco
Model	XR 1200 series
Category	Network Router
Language	English